Thermo-chemical conversion technologies (incineration, gasification and pyrolysis) have emerged as potential technologies for municipal solid waste management (MSWM). This is happening due to the increase of the need for clean and sustainable energy as a result of fossil fuel depletion. The increase in municipal solid waste (MSW) generation as well as land scarcity for MSW disposal is another reason in raising the potential for thermal technology. Incineration has been the most common thermo-chemical technology for solid waste disposal. However, due to environmental concern, gasification technology is currently becoming more preferable since it is environmental friendly for MSW disposal as well as energy recovery. The aim of this study is to analyze the flue gases obtained from the hybrid fixed bed gasifier during gasification of MSW. The fire was initiated by wood charcoal and six kilograms of MSW was fed in the gasifier. The combustion was supported by the air supplied by electric blower. The flue gas analyzer, TESTO 327-1 was used to analyze the concentration of CO, CO2 and O2. Results show that after 150 minutes of the gasification process, O2 concentration increased by 17.2% while CO and CO2 decreased by 0.0% and 3.77% respectively. The experimental results show that, during gasification process the O2 concentration was increasing with time while CO and CO2 concentration decreased.
| DOI | 10.11648/j.ajasr.20190504.12 |
| Published in | American Journal of Chemical and Biochemical Engineering (Volume 3, Issue 2, December 2019) |
| Page(s) | 68-73 |
| Creative Commons |
This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited. |
| Copyright |
Copyright © The Author(s), 2024. Published by Science Publishing Group |
Municipal Solid Waste, Municipal Solid Waste Management, Gasification, Hybrid Fixed Bed Gasifier, Thermochemical
| [1] | Ramzan, N., Ashraf, A., Naveed, S. and Malik, A. (2011). Simulation of hybrid biomass gasification using Aspen plus: A comparative performance analysis for food, municipal solid and poultry waste. Biomass and Bioenergy, 35 (9): p. 3962-3969. |
| [2] | Begum, S., Rasul, M. G., Akbar D. And Cork D. (2013). An experimental and numerical investigation of fluidized bed gasification of solid waste. Energies, 7 (1): p. 43-61. |
| [3] | Chen, C., Jin, Y., Yan, J. and Chi, Y. (2013). Simulation of municipal solid waste gasification in two different types of fixed bed reactors. Fuel, 103: p. 58-63. |
| [4] | Ingle, N. A. and Lakade, S. S. (2016). Design and development of downdraft gasifier to generate producer gas. Energy Procedia, 90: p. 423-431. |
| [5] | Moharkar, S. P. and Padole, P. D. (2012). Design and development of downdraft gasifier for rural area. International Conference on Emerging Frontiers in Technology for Rural Area (EFITRA) Proceedings published in International Journal of Computer Applications (IJCA). |
| [6] | Thakare, S. and Nandi, S. (2016). Study on potential of gasification technology for municipal solid waste (MSW) in Punecity. Energy Procedia, 90: p. 509-517. |
| [7] | Basu, P. (2006). Combustion and gasification in fluidized beds. Taylor and Francis. CRC press. |
| [8] | Zainal, Z. A., Ali, R., Lean, C. H and Seetharamu, K. N. (2001). Prediction of performance of a downdraft gasifier using equilibrium modeling for different biomass materials. Energy conversion and management, 42 (12): p. 1499-1515. |
| [9] | Han, J., Liang, Y., Hu, J., Qin, L., Street, J., Lu, Yand Yu, F. (2017). Modeling downdraft biomass gasification process by restricting chemical reaction equilibrium with Aspen Plus. Energy conversion and management, 153: p. 641-648. |
| [10] | Chen, C., Jin, Y., Yan, J. and Chi, Y. (2010). Simulation of municipal solid waste gasification for syngas production in fixed bedreactors. Journal of Zhejiang University-Science A, 11 (8): p. 619-628. |
| [11] | Meng, X. (2012). Biomass gasification: the understanding of sulfur, tar, and char reaction in fluidized bed gasifiers. MSc thesis submited in the process and energy Faculty, Delft University of Technology. |
| [12] | Kramreiter, R., Url, M., Kotik, J. and Hofbauer, H. (2008). Experimental investigation of a 125kW twin-fire fixed bed gasification pilot plant and comparison to the results of a 2MW combined heat and power plant (CHP). Fuel Processing Technology, 89 (1): p. 90-102. |
| [13] | Narendrabhai, S. S., Shaikh, M. H. and Sachin, P. (2018). Design, developmentand experimental studies of downdraft gasifier. International Journal of Advance Research, Ideas and Innovations in Technology, 4 (3):p. 7. |
| [14] | Ojolo, S. J. and Orisaleye J. I. (2010). Design and development of a laboratory scale biomass gasifier. Journal of Energy and Power Engineering, 4 (8). |
| [15] | Dong, J. (2016). MSWs gasification with emphasison energy, environment and life cycle assessment. Ecole des Minesd'Albi-Carmaux Zhejiang University. |
| [16] | Gao, W., Farahani M. R., Rezael, M., Hosamani, S. M., Jamil, M. K., Imran, M. and Baig, A. Q. (2017). Experimental study of steam-gasification of municipal solid wastes (MSW) using Ni-Cu/γ-Al2O3 nanocatalysts. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 39 (7): p. 693-697. |
| [17] | Lomasney, M., Michmerhuzen, N., Myton, N., and Sager, E. (2014). BIOburners. Final Design Report. Calvin College Engineering Department. |
| [18] | Chawdhury, M. A. and Mahkamov, K. (2011). Development of a small downdraft biomass gasifier for developing countries. Journal of scientific research, 3 (1): p. 51-51. |
| [19] | Sivakumar, S., Ragunathan, S. and Elango, N. (2014). Design and optimization analysis of 5kWe Downdraft Gasifier. Journal of Chemical and Pharmaceutical Sciences, 4: p. 141-143. |
| [20] | Jayah, T. H., (2002). Evaluation of a downdraft wood gasifier for tea manufacturing in SriLanka. Melbourne University: Victoria, Australia. |
| [21] | Bhavanam, A and Sastry, R. (2013). Modelling of solid waste gasification process for synthesis gas production. Journal of Scientific and Industrial Research, Vol 72. |
| [22] | Zwart, R., Vander Heijden, S., Emmen, R., DallBentzen, J., ahrenjeldt, J., Stoholm, P. and Krogh, J. (2010). Tar removal from low-temperature gasifiers. Petten: Energy Research Centre of the Netherlands (ECN). ECN-E-10-008. |
| [23] | Dhaundiyal, A. and Gupta, V. K. (2014). The analysis of pine needles as a substrate for gasification. Hydro Nepal: Journal of Water, Energy and Environment, 15: p. 73-81. |
| [24] | Plis, P. and Wilk, R. K. (2011). Theoretical and experimental investigation of biomass gasification process in a fixed bed gasifier. Energy, 36 (6): p. 3838-3845. |
| [25] | Zafar, S. (2009). Gasification of Municipal Solid Waste "Earthtoys Magazine "EESI. |
| [26] | Montes, F. D. d., (1986). Wood gas as engine fuel. FAO Forest paper, 72. |
| [27] | Omari, A., Said, M., Njau, K., John, G., and Mtui, P. (2014). Energy recovery routes from Municipal Solid Waste, A case study of Arusha-Tanzania. Journal of Energy Technologies and Policy, 4 (5): p. 1-7. |
| [28] | Suzdalenko, V., M. Gedrovics, and V. Vitolins, (2014). Experimental pilot device for thermal analysis of biomass co-firing. Agronomy Research, 12 (2): p. 611-622. |
APA Style
Robert Eliraison Moshi, Thomas Thomas Kivevele, Yusufu Abeid Chande Jande. (2020). Experimental Study of a Lab Scale Hybrid Fixed Bed Gasifier. American Journal of Chemical and Biochemical Engineering, 3(2), 68-73. https://doi.org/10.11648/j.ajasr.20190504.12
ACS Style
Robert Eliraison Moshi; Thomas Thomas Kivevele; Yusufu Abeid Chande Jande. Experimental Study of a Lab Scale Hybrid Fixed Bed Gasifier. Am. J. Chem. Biochem. Eng. 2020, 3(2), 68-73. doi: 10.11648/j.ajasr.20190504.12
AMA Style
Robert Eliraison Moshi, Thomas Thomas Kivevele, Yusufu Abeid Chande Jande. Experimental Study of a Lab Scale Hybrid Fixed Bed Gasifier. Am J Chem Biochem Eng. 2020;3(2):68-73. doi: 10.11648/j.ajasr.20190504.12
Share This Article
Twitter
Linked In
Facebook
Copy
Download@article{10.11648/j.ajasr.20190504.12,
author = {Robert Eliraison Moshi and Thomas Thomas Kivevele and Yusufu Abeid Chande Jande},
title = {Experimental Study of a Lab Scale Hybrid Fixed Bed Gasifier},
journal = {American Journal of Chemical and Biochemical Engineering},
volume = {3},
number = {2},
pages = {68-73},
doi = {10.11648/j.ajasr.20190504.12},
url = {https://doi.org/10.11648/j.ajasr.20190504.12},
eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ajasr.20190504.12},
abstract = {Thermo-chemical conversion technologies (incineration, gasification and pyrolysis) have emerged as potential technologies for municipal solid waste management (MSWM). This is happening due to the increase of the need for clean and sustainable energy as a result of fossil fuel depletion. The increase in municipal solid waste (MSW) generation as well as land scarcity for MSW disposal is another reason in raising the potential for thermal technology. Incineration has been the most common thermo-chemical technology for solid waste disposal. However, due to environmental concern, gasification technology is currently becoming more preferable since it is environmental friendly for MSW disposal as well as energy recovery. The aim of this study is to analyze the flue gases obtained from the hybrid fixed bed gasifier during gasification of MSW. The fire was initiated by wood charcoal and six kilograms of MSW was fed in the gasifier. The combustion was supported by the air supplied by electric blower. The flue gas analyzer, TESTO 327-1 was used to analyze the concentration of CO, CO2 and O2. Results show that after 150 minutes of the gasification process, O2 concentration increased by 17.2% while CO and CO2 decreased by 0.0% and 3.77% respectively. The experimental results show that, during gasification process the O2 concentration was increasing with time while CO and CO2 concentration decreased.},
year = {2020}
}
TY - JOUR T1 - Experimental Study of a Lab Scale Hybrid Fixed Bed Gasifier AU - Robert Eliraison Moshi AU - Thomas Thomas Kivevele AU - Yusufu Abeid Chande Jande Y1 - 2020/02/04 PY - 2020 N1 - https://doi.org/10.11648/j.ajasr.20190504.12 DO - 10.11648/j.ajasr.20190504.12 T2 - American Journal of Chemical and Biochemical Engineering JF - American Journal of Chemical and Biochemical Engineering JO - American Journal of Chemical and Biochemical Engineering SP - 68 EP - 73 PB - Science Publishing Group SN - 2639-9989 UR - https://doi.org/10.11648/j.ajasr.20190504.12 AB - Thermo-chemical conversion technologies (incineration, gasification and pyrolysis) have emerged as potential technologies for municipal solid waste management (MSWM). This is happening due to the increase of the need for clean and sustainable energy as a result of fossil fuel depletion. The increase in municipal solid waste (MSW) generation as well as land scarcity for MSW disposal is another reason in raising the potential for thermal technology. Incineration has been the most common thermo-chemical technology for solid waste disposal. However, due to environmental concern, gasification technology is currently becoming more preferable since it is environmental friendly for MSW disposal as well as energy recovery. The aim of this study is to analyze the flue gases obtained from the hybrid fixed bed gasifier during gasification of MSW. The fire was initiated by wood charcoal and six kilograms of MSW was fed in the gasifier. The combustion was supported by the air supplied by electric blower. The flue gas analyzer, TESTO 327-1 was used to analyze the concentration of CO, CO2 and O2. Results show that after 150 minutes of the gasification process, O2 concentration increased by 17.2% while CO and CO2 decreased by 0.0% and 3.77% respectively. The experimental results show that, during gasification process the O2 concentration was increasing with time while CO and CO2 concentration decreased. VL - 3 IS - 2 ER -
Information
Email: